SigOS: Hardware

The Signal Operating System is designed to operate on low-cost hardware. This encourages extensive use for Signals and Detectors throughout most railroads, large and small.

Components

Ribbon Cable

Ten conductor ribbon cable.

It is not necessary to use ribbon cable for wiring the hardware. However, it is low cost, convenient to work with, helps reduce "rats nest", and consistently using the same color wire for components simplifies construction and debugging.

• Wire gauge: 22, 24, or 26 AWG
• Source: Amazon.com

CdS photoresistor

Closeup of CdS (cadmium sulphide) photoresistor.

A CdS photoresistor is a light-sensitive resistor. It detects the ambient light at the signal head, which SigOS uses to control the brightness of the WS281 LEDs.

• Pin 1
  • Either wire from CdS photoresistor
  • Wire color: Green
  • Function: Variable voltage into GPIO P1 of Control Board A/D converter, voltage is inversely proportional to ambient light level
• Pin 2
  • Other wire from CdS photoresistor
  • Wire color: Yellow
  • Function: +3.3 volt power
• Part number: GL5516
• Characteristics: Bright light 5-10k Ohms, dark 0.2M Ohms
• Source: Amazon.com

WS281 LED

The WS281 LED is a low-cost, high intensity, multi-color LED. It is contains its own drive and control circuitry, making it extremely easy to integrate into the SigOS project. MicroPython on the ESP32 board directly supports driving the WS281 signals. Learn more about the WS281 here: WS2812b LED, MIT.

• 

  Frontside view of a sheet of WS281 LEDs.

• 

  Backside view of a sheet of WS281 LEDs.

• 

  Closeup of wiring side of WS281 LED.

• 

  Backside wiring of WS281 LED showing power and signal in on the left and daisy chaining to next LED on the right.

• 

  Prototype test box shows how multiple WS281 LEDs can be daisy chained together. In this case there are 3 signal heads, each with 3 LEDs.

• 

  Photo showing how nine WS281 LEDs are "daisy chained" together to form three signal heads with three LEDs each.

• Pin +5V In
  • Input +5 volts to power this LED and all downstram LEDs on the chain
• Pin GND In
  • Ground return for +5 volts and signal
• Pin DIn
  • Data Input signal, controls function of the LED
• Pin +5v Out
  • Output +5 volts to power downstream LEDs in the chain
• Pin GND Out
  • Output ground return for +5 volts and signal for downstream LEDs
• Pin DOut
  • Output data signal, controls function of downstream LEDs
• Part number: ALITOVE WS2812B
• Source: Amazon.com