Valve Timing

From IBLS
(Redirected from Setting valves)
Jump to navigation Jump to search


From Frank Williams, Locomotive Valve Setting, 1944:

Valve setting is a term generally applied to the work of making the final accurate adjustments to the valves and the valve gear of a locomotive before it is placed in service. These adjustments are made in order that the positions of the valves shall at all times bear their proper relation to the positions of the pistons. Valve setting follows the erection or hanging of the valve gear by the machinist.


Dead Center

See Dead center

Valve Formulas

From Larry Koehl, Live Steam Magazine, June 1976


Valve Travel formula.gif


Valve Cut Off formula.gif


The Throw of Eccentric formula, below, applies only to locomotives using Stephenson valve gear.


StephensonEccentricThrow formula.gif


Larry suggests adding up to 0.002 inches to the Throw of Eccentric value for each pin in the valve gear (including the eccentric, too) because, even when new, there will be lost motion, possibly enough to eliminate the lead.

Larry also points out the fact that Cut-Off is always 75% when Lap equals Port Width, for all values of Port Width.

See also Valves.

Types

See Valve Types

External Links